Let's Make A Robo

Step 1: Get all the materials needed!

ok so get all these.i got them mostly from broken toys,i'm sure you can find them at radioshack.

- a AA battery holder -> holding the batteries
- some solder wire -> soldering
- some wires -> connecting motor to switch,to batteries
- 2 AA batteries -> powering the motor
- 2 1.5V motors (preferably identical) -> making the robot move
- a slide switch -> ON,OFF
- 2 SPDT (Single Pole Double Throw) switches -> used for antenna
- 1-2 paperclips -> glue on the antennae so it is longer
- some glue sticks -> use with the hot glue gun

Step 2: Get all the tools needed!

i borrowed all the tools from my father,once again,they should be available at radioshack

- wire cutter and stripper ->cut wires and strip them
- pliers ->shape the antennas
- hot glue gun -> glue the switch and the SPDT switches on the battery holder
- a soldering iron -> solder and connect wires together
- a multimeter -> check the battery

Step 3: So,let's get started!

check the battery's power - =D

if its' on <<good>> use it

if it's on <<bad>> change it (in my case,regharge it)

Step 4: Some wires

solder the wires to the AA battery holder - i made the wires extra long on the blue battery holder so i don't mess it up,=)

don't forget the 3th connection!!!

it's the wire that connects the 2 batteries together

i changed the battery holder

Step 5: The antennae,part 1

glue it with the hot glue gun in front of the holder try to do it as perfect as possible

<-i'm a perfectionist->

try to do as in the picture

   

Step 6: The antennae,part 2

with the pliers,bent the paperclip into a straight line.

do your best, =\

Step 7: The antennae,part 3

cut the antenna with something pointy =)

I used the wire cutter/stripper

you will now have 2 small lines...

Step 8: The antennae,part 4

with the pliers,bend each line like in the photo

try to make them identical by putting one on top of the other or bending them together

Step 9: The antennae,part 5

the last part!

glue the 2 metal things on the top of the SDPT switches

Step 10: The motors

glue the motors at an angle of 40 degrees.

once again,do your best

Step 11: Some wheels!

i got these from a kinder toy,i honestly don't know where to buy some.sorry

glue it to the back of the AA battery holder.glue it a little lower so the holder doesn't touch the ground.if it does it will not go straight and will go slower

Step 12: Some more wires

ok so now connect the wires,do your best and look in the picture

Step 13: Some decoration!!!

be creative!

you can use my model,or create your own!

Step 14: The circuit diagram

well follow the pic and connect the wires

zoom it so you can see better

Step 15: How does it work?

when the robot hits a wall,it triggers the L or R switch which maked the opposite motor reverse for a couple of seconds.this makes it avoid obstacles

the picture may explain alot